Print then cut sticker border maker
Makerfern traces the art, then adds one smooth white border around it at the width you choose. The border has no holes, so the cut line is a single clean outline.
What this preset does
These are the starting values when you open this page. They are Makerfern's defaults, chosen to be sensible for the job, not a manufacturer specification. Every one is adjustable in the settings panel.
| Setting | Starts at | Why |
|---|---|---|
| Border | 3 mm | Gives the cut line room for small registration error. Widen it for kiss-cut sheets that will be handled a lot. |
| Width | 3 in | Sticker size. The border and limits are measured at this size. |
| Layers | Flat | Colors sit side by side, because the art is printed, not layered. |
| Smallest piece | 0.6 mm | Low, because printed detail isn't weeded; only the border is cut. |
Making the sticker
- Drop the design, set the sticker width, and adjust the border until it looks right.
- Download SVG, or the 300 dpi PNG if your software prefers an image for printing.
- In your cutting software, flatten the art onto the border so the border becomes the cut line, then print and cut.
Why the border has no holes
A plain offset around a donut shape produces a ring with a hole, and your machine will cut the hole too. A sticker should be one piece. Makerfern fills every enclosed gap in the border before tracing, so the cut is always a single outer path.
Why print-then-cut needs a margin
A printer and a cutter never line up perfectly. The border hides that: if the blade lands a fraction off, it cuts through white border rather than through your art. A wider border hides more error but makes a chunkier sticker, so 2–4 mm is a common range to try.
Questions
Can the border be a color other than white?
Yes. Click the border's swatch in the layer list and pick any color.
Is there a maximum print size?
Makerfern doesn't limit it, but cutting software often does for print then cut. Check your machine's current limit in its own help pages.